Windscreen
is one of the very essential parts of your vehicle. It is most necessary to check if the windscreen is adequately fitted or not. You have to take care of your vehicle’s
windscreen that should not be cracked or damaged. If your vehicle’s windshield is damaged or
broken, then you need to replace that windscreen with the new one. There are
some easy steps that you should follow at the time of windscreen replacement that is as follow:
•
Firstly, you will need to buy a new windscreen from an original
part dealer. You should make sure that the windscreen you have purchased is
free of any defects.
•
After buying a new windshield, you will have to prepare it for
installation. You will have to make your windscreen dust free by cleaning it
with the help of window cleaner. The outer black ceramic should be dust free.
After that you will have to prime the black ceramic with the help of a primer.
The primer will be used to install the windscreen by using a lint-free cloth.
You can’t touch it with your hands because your oily fingers can affect the
urethane.
•
After that, you have to fix the right moldings to glass. From the
vehicle, the rear-view mirror is detached. It is attached to the mirror
button. It is glued to the new windscreen
with a purpose made two-parts adhesive.
•
Next step is to remove the old windshield from the vehicle. For
this, you will need to remove all moldings.
After that you will need to use a cold knife use to cut the existing
urethane that was bonding on the top and another two sides of the windscreen. After that use the BTB knife to cut the bottom
section of the glass from the urethane whilst.
•
Now lift out the windscreen with the help of suction pumps. For
this, you need two people because windshield is decidedly more massive. After that cut the urethane with sharp knife
leaving a height of 1-2mm of urethane attached to the body.
•
Make sure the surface area of vehicle is dust free and also remove
the grease. Now, prime the surface of body with black primer.
•
Apply the automotive urethane to the glass surface area that is
primed by using a large caulking gun.
•
Attach the suction pumps outside the windscreen. Place the
windshield to the right position with the help of two people. Make sure that
the excellent contact between urethane and the body surface has made.
•
Fit all necessary molding, windscreen wipers and plenum chamber to
the vehicle and may sure the outside of the windscreen is cleaned.
•
Wait for at least 1 hour and then remove support tape from the
windscreen. Your windshield is replaced.
These
are the steps used for windscreen
replacement. When you are in Perth, Australia and want to replace your
vehicle’s damaged windscreen with the new one then you can contact to CSR Windscreens or you can visit http://csrwindscreens.com/.
I
hope you will like this blog and this blog will help you to how new windscreen replacement is done when
your vehicle’s old windscreen is cracked or damaged. Good Luck!
Comments
Post a Comment